KINETIQ

Dinker Control

Disconnected
LAUNCH CONTROL

Rate vs Position

Rate PI

Rate PI commands angular velocity. Position Ramp advances the position command at the selected °/s and uses Position PD to follow it.

CONTROLLER STATE Disconnected Connect to begin
Manual
PRESETS

Select Shot

Sequence off — using the selected preset.

PROJECTILE PREVIEW

Predicted Ball Trajectory

COMMAND SPEED—
ACTUAL AT RELEASE—
BALL SPEED—
TIME TO RELEASE—
Vx—
Vy—
HEIGHT—
RANGE—

Motor speed at release is predicted from the identified closed-loop model, then pure projectile motion is used: no drag or spin. 0° = vertical, 90° = horizontal. Fixed 10 m × 10 m scale. Net reference = 0.914 m; ceiling reference = 6 m.

LAUNCH ANGLE

Lower / Higher

90°
LowerHigher
MOVE SPEED

Slower / Faster

500°/s
SlowerFaster
MANUAL

Load Before Launch

Launch is rejected until a completed load is confirmed.

AUTOMATIC

Load → Launch → Repeat

6.0 seconds / shot
TEST DATA

Release Speed Measurements

0 saved
SLIDER—
COMMAND—
ACTUAL—
SIMULATED—

Each completed shot is saved automatically, including the selected launch-control mode.

Future SysID: the firmware's 2 kHz serial launch log records time, measured position, measured velocity, position command, rate command, motor command and rate error. The full 2 kHz log is captured by Serial MOVE/tuner; this BLE app stores the per-shot summary CSV.

MAX-SPEED TEST

20° → 80° Sweep

Ready

Runs one shot at each test point: 20°/1130, 30°/1390, 40°/1600, 50°/1790, 60°/1960, 70°/2120, 80°/2260 °/s.

BLE MONITOR

Commands & Status

Controller ready. Connect to KinetIQ Motor.